NOTHING. Zip. Zero. Zilch. Nada. Nil. That's what you have to do to connect and disconnect InvisiBrake.
There's nothing to take in and out of your towed vehicle and there's nothing to push, pull, set, adjust, activate or deactivate.
What could be easier than nothing at all?
What is InvisiBrake?
InvisiBrake is a fully-automatic supplemental braking system that uses the electrical connections already in place on your towed vehicle (the towed vehicle’s electrical harness) to brake when you brake the motorhome the same electrical signal that activates the towed vehicle’s brake lights also activates InvisiBrake.
Features
• Completely out of sight InvisiBrake is so small (8¾" x 8¾" x 2¾") it can usually be mounted under the driver’s seat, under the rear seat, behind interior panels or in the trunk, without sacrificing any of the vehicle’s usable space.
• Set it and forget it braking Once it's installed, InvisiBrake just works. There's nothing for you to remember not even an on switch just plug in the umbilical cord like you always do and you're reayd to go!
• Charges your battery while towing InvisiBrake connects directly to the towed vehicle’s battery and trickle charges the battery during towing InvisiBrake will never drain the battery.
• Two-stage motorhome monitor InvisiBrake includes an LED monitor for a visual reference of braking activity; an audible alert at the motorhome will warn you if the brakes have been on for too long.
• Activates only when the motorhome’s brake lights illuminate — no false braking!
• Energizes your power brakes most braking systems work on a 'dead' brake pedal. InvisiBrake energizes your power brakes so that you have the same power braking system while towing as you do while driving.
• Works in virtually any towed vehicle with vacuum-powered brakes including hybrids and those with 'active' (or 'continuous power assist') braking systems. To see if InvisiBrake works with your vehicle, check our fit list.
• Includes an emergency break away system
• Easily adjusts to individual braking preferences braking pressure is adjustable from five to 100 psi.
• Meets U.S. and Canadian braking requirements
8700
InvisiBrake
Specifications
Controller Size — 8¾" x 8¾" x 2¾"
Voltage — 12 volts DC
Fuse size — 20 amp
Operating temperature range —
-2° to +150° F (-19° to +66° C)
Maximum amperage draw — 10.8 amps
Idle amperage draw — 6mA
Battery recharging rate — up to 2 amps
Approximate maximum air pressure — 100 psi
Why Do I Need Supplemental Brakes?
How do you stop a stick of dynamite? If you tow a vehicle behind your motorhome, that’s not a rhetorical question at highway speeds, the momentum of a 3,000-pound towed vehicle (say, a Ford Focus) has the kinetic energy of a quarter stick of dynamite (425,000 foot pounds of force). A 6,000-pound Jeep Grand Cherokee has the kinetic energy of a half stick of dynamite (850,000 foot pounds of force). And, a 10,000-pound Chevy Silverado has the kinetic energy of three-quarters of a stick of dynamite (almost 1,500,000 foot pounds of force).
That’s according to the law the second law of motion.
Like every other law of physics, the second law of motion “force equals mass times acceleration” isn’t open for debate. “Mass” (the weight of the towed vehicle) times “acceleration” (65 miles an hour, in the examples above) equals “force.” Always. Which creates, in effect, a 3,000 to 10,000 pound battering ram aimed directly at the back of the coach.
The laws of physics don’t recognize state boundaries. So it doesn’t matter whether you’re towing in Texas, Massachusetts or British Columbia there’s no getting around the long arm of the second law of motion. Or, for that matter, the third law of motion “for every action, there is an equal and opposite reaction” every time you hit the brakes.
Motorhome brakes aren’t built to stop an additional 3,000 or 4,000 (or 10,000) pounds of towed weight.They’re built to stop the weight of the coach and its contents.
But even if you had an extra two or three tons of braking capacity, the weight of a towed vehicle isn’t over the motorhome’s brakes. It’s pushing on them from behind.
So it’s not surprising, then, that safety is the number one reason most people add a supplemental braking system. Supplemental brakes take the load off the motorhome, and the motorhome and the towed vehicle brake in tandem, taking significantly less time and distance to come to a controlled stop approximately 34 percent less, according to a study* by ROADMASTER (see the “Test Results at 50 mph" chart).
Supplemental brakes also relieve stress on the tow bar and the mounting brackets — a panic stop without supplemental brakes is a leading causes of tow system failure. They also keep the combination straight as you brake, so there’s less chance of a “jackknife.” And supplemental brakes reduce the chance of a catastrophic brake failure at the motorhome, as a result of sustained braking — for example, when you’re driving down a steep grade in the mountains.
Safety notwithstanding, there are several other compelling reasons to add supplemental brakes…
It’s required To one degree or another, every state and province in North America has recognized what the second law of motion implies. Which is why supplemental brakes are required in virtually every state and province. The majority of states, plus many Canadian provinces, specify 3,000 pounds as the maximum weight which can be towed without supplemental brakes, according to the American Automobile Association.
There’s currently no national standard, and the towed weight limits vary from state to state (and in Canada, from province to province) 4,500 pounds in Texas, 10,000 pounds in Massachusetts, and 3,080 pounds in British Columbia (again, according to the American Automobile Association).
There is, however, that universal standard “force equals mass times acceleration.” Whether you’re in Texas, Massachusetts or British Columbia, every towed vehicle combination is always in compliance with the second law of motion.
Chassis warranty and liability Some motorhome chassis manufacturers will void your warranty (and insurance adjusters will void your policy) against damage claims if you tow without supplemental brakes. Workhorse will void your chassis warranty if you tow more than 1,000 pounds without supplemental brakes; Ford stipulates 1,500 pounds.
Wear and tear — Supplemental brakes cut down on everyday wear and tear — on the tow bar and the bracket, and on the frame of the towed vehicle. So they last longer. And because they aren’t braking for two vehicles, your motorhome’s brakes last longer, also.
It just makes good sense Every other trailer on the road today has supplemental brakes fifth wheels, travel trailers, semi-trailers — they all have their own braking systems. When you’re towing a couple of extra tons — or more shouldn’t you have a supplemental braking system to stop it?
Which system is right for me?
* Test data — Motorhome: 34-foot 1996 Winnebago Adventurer, Ford Superduty chassis with a 460 gas engine; GVWR: 17,000 pounds; brakes: hydraulic four-wheel disc. Towed vehicle: 1995 Oldsmobile Aurora; GVWR: 4,690 pounds (actual test weight: 4,110 pounds). Braking pressure: 80 pounds of force directed to the brake pedal representing a “hard stop.”
Roadmaster Invisibrake is made in the United States Of America..
Amazon affiliate Disclaimer
Joseph Cannon is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com.
No comments:
Post a Comment